The latest upgrade packs are available above. You can upgrade your primary installation of Key Manager Plus by following the below steps. Next, you can uninstall Key Manager Plus application completely from the other servers. With this, the failover service will be deactivated. Open a command prompt in any of the servers.You can deactivate the failover service either from the primary or the secondary server. Upgrade the primary application server.In a failover service set up with two application servers bound to an MS SQL cluster, you can upgrade only the primary server the secondary server must be reinstalled and the failover service setup must be reconfigured. However, this is a one-time operation and you need not repeat the process during the next version upgrade. Please note that importing the SSL certificate is mandatory while upgrading KMP from version 6.2 to 6.3. After applying the upgrade packs, login as a root user and start the KMP service, using /etc/rc.d/init.d/sshkeymanager-service start.If you are applying multiple upgrade packs, do the following for each upgrade exit the Update Manager, start & stop the KMP service once, and execute the upgrade steps.Please note that the SSL certificate import is a one-time operation and you need not repeat the process during the next version upgrade. Once the certificate is imported successfully, wait for the upgrade to complete until the message "Service Pack applied successfully" is displayed. Enter the SSL certificate's absolute path when prompted.As a part of patch integrity verification from KMP build 6300 onwards, you must import an SSL certificate to install the upgrade.Execute the command sh UpdateManager.sh -c (This will run the Update Manager in CLI mode).To begin the upgrade, navigate to /bin directory using a terminal. The upgrade pack is to be applied through a tool named UpdateManager bundled with Key Manager Plus.Stop KMP service using the command /etc/rc.d/init.d/sshkeymanager-service stop.In case you store the database_nf file at a different location, you must copy the file back to the original location (i.e. Also, when applying multiple upgrade packs sequentially, it is recommended that you start the Key Manager Plus service after each upgrade to ensure the corresponding build version runs successfully without any issue.Then proceed with running the Update Manager tool to apply the next upgrade pack and so on If you are applying multiple upgrade packs one-by-one, exit the Update Manager tool after applying one upgrade pack and make sure that the database process is not running. Click Close and then click Exit to exit the Update Manager tool. Wait for a few minutes until the upgrade pack is fully installed. Click Install in the Update Manager window to begin the upgrade process.In the pop-up that opens, click Browse and import the SSL certificate you downloaded from the aforementioned page.Click here to download the SSL certificate to be imported. As a part of patch integrity verification from KMP build 6300 onwards, you must import an SSL certificate to complete the upgrade process. To begin the upgrade, navigate to the /bin directory and execute the command UpdateManager.bat to start the Update Manager. In case something goes wrong with the upgrade, you can revert to this copy, with your settings intact. Take a backup of the entire Key Manager Plus installation folder and store it in some other location. Also ensure that you stop the Key Manager Plus server before applying the upgrade pack. If something goes wrong with the Key Manager Plus upgrade, you can rely on the copy. IMPORTANT: Take a copy of the entire Key Manager Plus installation folder before applying the upgrade pack and keep it in some other location.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |